BDS 4" LIFT KIT 2009-2013 F150 4WD (598H)

This image is a representation of the product only. Actual product may vary in appearance.

SKU: BDSK-BDS598H

Available

Item sold as a kit. call 800-365-8610 for component availability.

Pricing: $2,055.36

Description
Prop 65 Notice
Important Notes
Vehicle Fitment
Details
Shipping
Documents

Description

BDS Suspension 4" Suspension Lift Kit System for 2009-2013 Ford F150 4WD pickup trucks. This system includes CNC machined steering knuckles to return your vehicle's steering to factory geometry. One piece front & rear High Clearance crossmembers increase rigidity for long term performance as well as dramatically increase ground clearance and curb appeal.. A 1/4" thick steel differential skid plate and is included to ensure off road protection. This system uses upper front strut spacers to ease installation. The rear is lifted with a new offset 4" rear block that replaces the factory 2" block and centers the rear axle to clear up to 35's.. Check out the similar 6" lift install article published in Four Wheeler magazine.

Prop 65 Notice

ATTENTION STATE OF CALIFORNIA CONSUMERS: *WARNING* Cancer and reproductive harm-www.p65warnings.ca.gov

Important Notes

1. Requires frame bracket modification and welding. 2. 18" or larger diameter wheels required. Stock 17" & 18" wheels cannot be reinstalled. Stock 20" wheels can be used with up to a 305/60-20 tires. 3. E-brake bracket required for factory powersteps (123018) 4. For a level to tail low appearance use #023415 with Kit#598H. Block kits replace factory 1-1/4" block. 5. Early 2009 models may require brake assembly modification. 6. Will fit EcoBoost models. 7. Models equipped with AWD/ Auto 4wd may require front driveshaft replacement. 8. This kit is FMVSS No.126 Compliant The NHTSA's Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well. BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.

Tire & Wheel Combinations
35" x 12.50" ** w/18 x 9 and 5" back spacing
35" x 12.50" ** w/20 x 9 and 4.5-5.5" back spacing
*Trimming may be required*

Est. Installation: 8-10 hours
Difficulty Level (easy 1 - 5 complicated): 4